Grandstream Networks GXV3350 Administration Manual page 31

DND Call Feature Off
No Key Entry Timeout (s)
Ring Timeout (s)
Refer-To Use Target Contact
RFC2543 Hold
Call Forward
Call Forward Type
Dial Plan
Dial Plan Prefix
Disable Dial Plan
Configures the feature code to disable the DND
(Do Not Disturb) feature for this account.
If it is configured, the phone will dial the feature
code automatically when the DND feature is
disabled.
Determines the expiration timer (in seconds) for
no key entry. The dialed digit will be sent out if
no other digits entered within the set period. The
default value is 4 seconds. The valid range is
from 1 to 15. This feature does not work if the
dialer page is entered via the Account Widget on
the phone.
Defines the expiration timer (in seconds) for the
rings with no answer. The default setting is 60.
The valid range is from 10 to 300.
Sets the phone system to use the target's Contact
header tag to the Refer-To header in the SIP
REFER message during an attended transfer.
The default setting is "No".
If yes, c=0.0.0.0 will be used in INVITE SDP for
hold.
Sets the Call Forwarding feature for this account.
● None: Disable call forwarding feature.
● Unconditional: Set to forward all calls to a
specified account.
● Time based: Set the call forwarding rule
based on time. The system can forward
incoming calls to the accounts of In Time
Forward to and Out Time Forward to.
● Others: Set the call forwarding rule based on
following account status.
● Forward when Busy: the call will be
forward to number set under "Busy To"
when the account is busy.
● Forward when No Answer: The call will be
forwarded to the number set under "No
Answer To" after the configured timeout.
(range 1- 120s)
● Forward when DND: When the phone is on
DND mode the call will be forwarded to
number configured under "DND To".
Configures the digits prepended to the dialed
number.
Enables/disables the Dial plan mechanism for
different cases. If the specific case is checked,
the Dial plan mechanism will be disabled.
● Dial Page: It controls the pattern of dialing
numbers from the keypad, phone app and
account widget.