Network Settings Page Definitions; Network Settings/Ethernet Settings - Grandstream Networks GXV3350 Administration Manual

Specifies the H.264 codec profile type for the multicast paging call. This list includes "Baseline Profile",
Multicast "Main Profile", and "High Profile".
Paging H.264
Note: Lower profile is easier to decode, while higher profile has higher compress rate. Usually, use
Profile Type
Baseline profile for low CPU Performance device, and choose high profile for video conference.
Multicast
Determines the H.264 codec payload type for the multicast paging call.
Paging H.264
The default setting is "99".
Payload Type
Multicast
Listening
Configures the IP address and port number for monitoring multicast paging call. When the initiator
initiates a call, answer the call and display listening address and tag of the monitoring target. This feature
Priority
supports Video Multicast, when the initiator initiates Video Multicast, it will automatically add the number
Listening
2 on the port of the listening address. Reboot the phone to make changes take effect.
Address
Label
The valid IP address range is from 224.0.0.0 to 239.255.255.255. Users may also fill the label for each
listening address corresponding to priority.

Network Settings Page Definitions

Network Settings/Ethernet Settings

Ethernet Settings
If IPv4 is selected, the phone will be using IPv4 addressing, otherwise, it will be using IPv6
IP Mode
addressing. Default is Prefer IPv4.
Different
Configures whether to set up different networks for the phone data and the call. If set to "Yes", you
Networks for Data
need to configure the data network and VoIP network respectively.
and VoIP Calls
IPv4
Configures the appropriate network settings on the phone.
IPv4 Address Type
Users could select from "DHCP", "Static IP" or "PPPoE"(Point-to-point Protocol over Ethernet). By
default, it is set to "DHCP".
Selects the DHCP Option VLAN mode. When set to "DHCP Option 132 and DHCP option 133", the
phone will get DHCP option 132 and 133 as VLAN ID and VLAN priority. When set to "Encapsulated
in DHCP Option 43", the phone will get values from Option 43 which encapsulate VLAN ID and VLAN
DHCP VLAN
priority.
Override
Note: Please make sure the "Allow DHCP Option 43 and Option 66 to Override Server" setting under
maintenance��upgrade is checked. The default setting is " Encapsulated in DHCP Option 43 ".
DHCP Host name Sets the name of the client in the DHCP request. It is optional but may be required by some Internet
(Option 12) Service Providers.
Table 19: Phone Settings/Multicast Paging