Phone Settings/Ring Tone; Phone Settings/Video Settings - Grandstream Networks GXV3350 Administration Manual

Return Code When
Enable DND
Group Listen with
Speaker
One-way Call Function
Buttons
Conference Call Function
Buttons
Mute Key Functions
While Idle
Call Function Button
Display Timeout (s)

Phone Settings/Ring Tone

Auto Config CPT by Region
Call Progress Tones:
● Dial Tone
● Second Dial Tone
● Ring Back Tone
● Busy Tone
● Reorder Tone
● Confirmation Tone
● Call-Waiting Tone
Call-Waiting Tone Gain
Default Ring Cadence

Phone Settings/Video Settings

Video Frame Rate
When DND is enabled, the phone will send the selected type of SIP
message.
Configures whether to enable speaker sound when in a call with
handset/headset. If set to "Yes", the speaker sound is enabled, but you
cannot talk through the speaker.
Users can configure and customize the call functions in the call interface
during a normal call. The available call functions are: Conf, Hold, Video,
Record, Call Details, MPK.
Note: Users can choose only 2 of these functions to be shown on the call
interface during a one-way call.
Users can configure and customize the call functions in the call interface
during a conference. The available call functions are: Invite, Hold, Record,
Call Details, MPK.
Note: Users can choose only 2 of these functions to be shown on the call
interface during a conference.
This feature allows the user to configure what mute button will do when
pressed in idle state. If set to "DND", pressing the mute button will not
receive any incoming calls. If set to "Mute when idle", pressing the mute
button will mute answered calls. If set to "Disabled"
Configures the timeout period for call function buttons display. If set to "0",
the buttons will be always displayed. The value range is 0-30 seconds.
Table 16: Phone Settings/Call Settings
Configures whether to choose Call Progress Tone automatically by region. If set to
"Yes", the phone will configure CPT (Call Progress Tone) according to different
regions automatically. If set to "No", you can manually configure CPT parameters.
The default setting is "No".
Configures tone frequencies according to user preference. By default, the tones are
set to North American frequencies. Frequencies should be configured with known
values to avoid uncomfortable high pitch sounds.
Syntax: f1=val,f2=val [,c=on1/off1[-on2/off2[-on3/off3]]]. (Frequencies are in Hz
and cadence on and off are in 10ms)
ON is the period of ringing ("On time" in "ms") while OFF is the period of
silence. In order to set a continuous ring, OFF should be zero. Otherwise it will
ring ON ms and a pause of OFF ms and then repeats the pattern.
Please refer to the document below to determine your local call progress
tones: https://www.itu.int/ITU-T/inr/forms/files/tones-0203.pdf
Adjusts the call waiting tone volume. Users can select "Low", "Medium" or
"High". The default setting is "Low".
Defines the ring cadence for the phone. The default setting is: c=2000/4000.
Table 17: Phone Settings/Ring Tone
Configures video frame rate for SIP video call from "5 frames/second", "15
frames/second", "25 frames/second" and "30 frames/second". The default setting
is 15 frames/second. The video frame rate is adjustable based on network
conditions. Increasing the frame rate will significantly increase the amount of data