Network Settings; Ethernet Settings; Advanced Settings - Grandstream Networks GHP6 Series Administration Manual

Network Settings

Ethernet Settings

Internet Protocol
IPv4 Address
IPv4 Address
Host name (Option 12)
Vendor Class ID (Option 60)
DNS Server 1
DNS Server 2
Preferred DNS Server
IPv6 Address
IPv6 Address
DNS Server 1
DNS Server 2
Preferred DNS Server

Advanced Settings

DNS Refresh Timer (m)
DNS Failure Cache Duration (m)
Enable LLDP
LLDP TX Interval
Enable CDP
Layer 3 QoS for SIP
Select Prefer IPv4 or Prefer IPv6
The IPv4 address obtained by the phone.
Specifies the name of the client. This field is optional but may be required by Internet Service
Providers.
Used by clients and servers to exchange vendor class ID.
Enter DNS Server 1 when static IP is used.
Enter DNS Server 2 when static IP is used.
Enter the Preferred DNS Server.
The IPv6 address obtained by the phone.
Enter DNS Server 1 when static IP is used.
Enter DNS Server 2 when static IP is used.
Enter the preferred DNS server.
Advanced Network Settings
Configures the refresh time (in minutes) for DNS query. If set to "0", the phone will use
the DNS query TTL from DNS server response.
Configures the duration (in minutes) of previous DNS query fails. If set to "0", the
feature will be disabled.
Note: Only valid for SIP registration.
Controls the LLDP (Link Layer Discovery Protocol) service.
Configures LLDP TX Interval (in seconds). Valid range is 1 to 3600.
If enabled, the device will use the Cisco Discovery Protocol feature.
Configures the layer 3 QoS parameter for SIP. This value is used for IP Precendence,
DiffServ, or MPLS.