Mitsubishi Electric MR-E A Series Instruction Manual page 296

15. MR-E-
Class No. Symbol
76
77
78
79
80
www.DataSheet4U.com
81
82
83
84
15.5 Display and operation
15.5.1 Display flowchart
Use the display (5-digit, 7-segment LED) on the front panel of the servo amplifier for status display,
parameter setting, etc. Set the parameters before operation, diagnose an alarm, confirm external
sequences, and/or confirm the operation status. Press the "MODE" "UP" or "DOWN" button once to move
to the next screen.
To refer to or set the expansion parameters, make them valid with parameter No. 19 (parameter write
disable).
AG SERVO AMPLIFIER COMPATIBLE WITH ANALOG INPUT
TL2 Internal torque limit 2
Set this parameter to limit servo motor torque on the assumption
that the maximum torque is 100[%].
When 0 is set, torque is not produced.
When torque is output in analog monitor output, this set value is the
maximum output voltage ( 8V).
For manufacturer setting
Don't change this value by any means.
POINT
For the alarm mode, parameter mode output signal (DO) forcible output
and test operation mode, refer to Chapter 6.
Name and function
15 - 51
Initial Setting Control
Unit
value range mode
100 % 0 S T
to
100
00
10000
10
10
100
100
100
0000