Mitsubishi Electric MR-E A Series Instruction Manual page 102

5. PARAMETERS
Class No. Symbol
44
www.DataSheet4U.com
45
46
*DI3 Input signal selection 3 (CN1-3)
Allows any input signal to be assigned to CN1-pin 3.
The assignable signals and setting method are the same as in input
signal selection 2 (parameter No. 43).
0 0
Position
control mode
Internal speed
control mode
This parameter is unavailable when parameter No. 42 is set to
assign the control change (LOP) to CN1-pin 3.
This parameter is unavailable when parameter No. 48 is set to
assign the Forward rotation stroke end (LSP) and Reverse rotation
stroke end (LSN) to be assigned to CN1-pin 3.
Input signal selection 4 (CN1-5)
*DI4
Allows any input signal to be assigned to CN1-pin 5.
The assignable signals and setting method are the same as in input
signal selection 2 (parameter No. 43).
0 9
Position
control mode
Internal speed
control mode
This parameter is unavailable when parameter No. 42 is set to
assign the control change (LOP) to CN1-pin 5.
This parameter is unavailable when parameter No. 48 is set to
assign the Forward rotation stroke end (LSP) and Reverse rotation
stroke end (LSN) to be assigned to CN1-pin 5
Input signal selection 5 (CN1-6)
*DI5
Allows any input signal to be assigned to CN1-pin 6.
The assignable signals and setting method are the same as in input
signal selection 2 (parameter No. 43).
0 0
Position
control mode
Internal speed
control mode
This parameter is unavailable when parameter No. 42 is set to
assign the control change (LOP) to CN1-pin 6.
This parameter is unavailable when parameter No. 48 is set to
assign the Reverse rotation stroke end (LSN) to be assigned to CN1-
pin 6.
Name and function
Input signals of
CN1-pin 3
selected.
Input signals of
CN1-pin 5
selected.
Input signals of
CN1-pin 6
selected.
5 - 17
Initial Setting Control
Unit
value range mode
0882 P S
Refer to
Name
and
function
column.
0995 P S
Refer to
Name
and
function
column.
0000 P S
Refer to
Name
and
function
column.