Commands And Responses - SMART Board 6065 HD Installation And Maintenance Manual

APPENDIX B
REMOTELY MANAGING THE DISPLAY
Standby
l
All commands are available when the display is on. Some commands are available when the
display is in Standby mode.

Commands and responses

To access display information or to adjust display settings using the room control system, type
commands after the command prompt (>), and then wait for the response from the display.
CORRECT
>get contrast
contrast=55
If you type a command that the room control system doesn't recognize, you will receive an invalid
command response.
In the example below, the user included an extra space in the contrast command.
INCORRECT
>set con trast=65
invalid cmd=set con trast=65
NOTES
Use ASCII formatted commands.
l
Commands aren't case-sensitive.
l
Review each entry carefully before you press ENTER.
l
Don't send another command until you receive the response and the next command
l
prompt.
To view a list of available commands
Type ? at the command prompt, and then press ENTER.
53 smarttech.com/kb/171204