Table of Contents
Advertisement
Mounting on the wall and projecting forward
Menu item
[PROJECTION METHOD]
Note
f The projector has a built-in angle sensor. The attitude of the projector is automatically detected by setting the [PROJECTOR SETUP] menu
→ [PROJECTION METHOD] to [AUTO]. For rear projection, set the [PROJECTION METHOD] to [REAR/DESK] or [REAR/CEILING].
rAngle sensor
The range of installation posture detected by the projector's built-in angle sensor is as follows.
[FRONT/DESK]
Parts for ceiling mount or wall mount (optional)
r When installing on a ceiling
The projector can be installed on the ceiling by combining the optional Ceiling Mount Bracket (Model No.:
ET-PKD120H (for High Ceilings), ET-PKD120S (for Low Ceilings), ET-PKD130H (for High Ceilings, 6-axis
Adjustment)) and the Ceiling Mount Bracket (Model No.: ET-PKE301B (Projector Mount Bracket)).
f Use only the ceiling mount brackets specified for this projector.
f Refer to the Installation Instructions for the ceiling mount bracket when you install the bracket and the projector.
r When installing on a wall
The projector can be installed on the wall by using the optional wall mount bracket (Model No.: ET-WBC100).
When replacing the projector mount bracket of the existing wall mount bracket (Model No.: ET-WBC100), use the
optional projector mount bracket (Model No.: ET-PKC300B).
f Use only the wall mount brackets specified for this projector.
f Refer to the Installation Instructions for the wall mount bracket when you install the bracket and the projector.
Attention
f To ensure projector performance and security, installation of the ceiling mount bracket or wall mount bracket must be carried out by your
dealer or a qualified technician.
Chapter 2 Getting Started - Setting up
Method
[AUTO] or [FRONT/CEILING]
Mounting on the wall and projecting from rear
(Using the translucent screen)
Menu item
[PROJECTION METHOD]
30°
30°
:
Projection direction
Method
[REAR/CEILING]
[FRONT/CEILING]
ENGLISH - 33
Advertisement
Chapters
Table of Contents
