Setting Up; Projection Method; Parts For Ceiling Or Wall Mount (Optional) - Panasonic PT-CW230EA Operating Instructions Manual

Setting up

Projection method

You can use the projector with any of the following 4 projection methods. To set the desired method in the projector.
Mounting on the ceiling and
projecting forward
Setting on a desk/floor and
projecting from forward
Attention
For optimum viewing quality, install the projector in a location where screen exposure to outside light, light from light fixtures
or other light is at a minimum. Also draw the curtains, close blinds and turn off light fixtures.
Do not use the projector installed vertically or tilted right or left. Use under such conditions could result in equipment damage.
Do not roll the projector more than 10 degrees from side to side.
Do not roll the projector more than 5 degrees from side to side
when front or rear is downward.
10˚
10˚

Parts for ceiling or wall mount (Optional)

You can install the projector on the ceiling or wall by using the optional ceiling mount bracket (ET-PKV100H: for
high ceiling, ET-PKV100S: for low ceiling, ET-PKC100W: for wall hanging), and the optional projector mount base
ET-PKC100B.
Use only the ceiling mount brackets specified for this projector.
Refer to the installation manual for the ceiling mount bracket when you install the bracket or hanger and the projector.
Attention
To ensure projector performance and security, installation of the ceiling mount bracket must be carried by your
dealer or a qualified technician.
Mounting on the ceiling and
projecting from rear
(Using translucent screen)
Setting on a desk/floor and
projecting rear
(Using translucent screen)
5˚ 5˚
5˚ 5˚
21
ENGLISH -