Table of Contents
Advertisement
f The [DIGITAL CINEMA REALITY] individual adjustment screen is displayed.
3)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
[DYNAMIC CONTRAST]
Light adjustment of the light source and signal compensation are performed automatically according to the image
to make the contrast optimum for the image.
1)
Press as to select [DYNAMIC CONTRAST].
2)
Press qw or the <ENTER> button.
f The [DYNAMIC CONTRAST] individual adjustment screen is displayed.
3)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[1]
[2]
[USER]
Note
f [DYNAMIC CONTRAST] can be adjusted only when there is a signal input. Its settings are effective only when no on-screen display such as
menu screen (OSD) or input guide, a test pattern, or a warning message is displayed.
Setting the light off condition of the light source
1)
Press as to select [DYNAMIC CONTRAST].
2)
Press qw or the <ENTER> button.
f The [DYNAMIC CONTRAST] individual adjustment screen is displayed.
3)
Press qw to select [USER].
4)
Press the <ENTER> button.
f The [DYNAMIC CONTRAST] screen is displayed.
5)
Press as to select the item to set.
f The items in the detailed setting will switch each time you press qw.
Setting item
[LIGHTS OUT TIMER]
(Setting of the waiting time
before turning off the light)
[LIGHTS OUT SIGNAL LEVEL]
(Setting of the brightness level
of the signal to turn off the
light)
Note
f [LIGHTS OUT SIGNAL LEVEL] cannot be set when [LIGHTS OUT TIMER] is set to [DISABLE].
f When [LIGHTS OUT TIMER] is set to anything other than [DISABLE], the following are the conditions to turn the light source back on again
from the state that the light source has turned off by this function.
g When the brightness level of the image signal being input has exceeded the value set in [LIGHTS OUT SIGNAL LEVEL]
g When the input signal is gone
g When on-screen display such as menu screen (OSD) or input guide, a test pattern, or a warning message is displayed
f When the image of analog signal is projected, the image may be affected by the signal noise while the brightness level of the image signal
is detected. In such case, it is determined that the signal has not fallen below even when the brightness level of the image falls below the
value set in [LIGHTS OUT SIGNAL LEVEL].
70 - ENGLISH
Chapter 4 Settings - [PICTURE] menu
Performs no cinema processing.
Performs cinema processing.
Disables the dynamic contrast function.
Adjusts the light source and compensates signals to a small extent.
Adjusts the light source and compensates signals to a large extent.
The light source can be set to turn off when the brightness level of the input image signal falls below a
certain value.
Refer to "Setting the light off condition of the light source" (x page 70) for details.
[DISABLE]
Does not turn off the light source.
Turns off the light source when the brightness level of the image signal
being input goes under the value set in [LIGHTS OUT SIGNAL LEVEL].
[0.5s] ~ [10.0s]
Select an item from [0.5s] - [4.0s], [5.0s], [7.0s], or [10.0s].
[0.5s] - [4.0s] can be selected in increments of 0.5.
Sets the level of the brightness of the image signal to turn off the light
[0%] ~ [5%]
source with [LIGHTS OUT TIMER].
Can be set in increments of 1%. (Factory setting: 0%)
Details
Advertisement
Chapters
Table of Contents
