Table of Contents
Advertisement
Setting the administrator account
Set the user name and password of the administrator account.
1)
Press as to select [USER NAME], and press the <ENTER> button.
f The [USER NAME] screen is displayed.
f The factory default setting of user name is "dispadmin".
2)
Press asqw to select a character, and press the <ENTER> button.
f Up to 16 characters can be entered.
3)
After entering the user name, press asqw to select [OK], and press the <ENTER> button.
f The [ADMINISTRATOR ACCOUNT] screen is displayed.
4)
Press as to select [PASSWORD], and press the <ENTER> button.
f The [PASSWORD] screen is displayed.
5)
Press asqw to select a character, and press the <ENTER> button.
f Up to 16 characters can be entered.
f The password cannot be blank.
6)
After entering the password, press asqw to select [OK], and press the <ENTER> button.
f The [ADMINISTRATOR ACCOUNT] screen is displayed.
7)
Press as to select [PASSWORD CONFIRM], and press the <ENTER> button.
f The [PASSWORD CONFIRM] screen is displayed.
8)
Enter the password entered in Step 5).
9)
After entering the password, press asqw to select [OK], and press the <ENTER> button.
f The [ADMINISTRATOR ACCOUNT] screen is displayed.
10) Press as to select [STORE], and press the <ENTER> button.
f The confirmation screen is displayed.
11) Press qw to select [OK], and press the <ENTER> button.
Note
f For restrictions on character strings that can be set for password, refer to [PASSWORD POLICY] (x page 48).
f By pressing the <MENU> button while the [ADMINISTRATOR ACCOUNT] screen is displayed, you can proceed to the next operation
without setting an administrator account password, but the network function of this projector cannot be used. To use the web control function
or the communication control (including operation with application software) via LAN, set a password.
f If you press the <MENU> button while the [ADMINISTRATOR ACCOUNT] screen is displayed, the [ADMINISTRATOR ACCOUNT]
screen will not be displayed the next time the power is turned on. To use the network function, set a password in the [NETWORK] menu →
[ADMINISTRATOR ACCOUNT].
f The user name and password of the administrator account can also be changed on the [Set up password] page (x page 149) of the web
control screen.
f The user name and password of the standard user account without administrator rights can be set on the [Set up password] page
(x page 149) of the web control screen.
Chapter 3 Basic Operations - Switching on/off the projector
PASSWORD POLICY
- Reusing passwords is not recommended.
- Password cannot be blank.
- A password consisting of at least eight half-width characters
and contaning characters of at least three of the
following four types is recommended.
- Uppercase letters
- Lowercase letters
- Digits
- Symbols(~!@#$%^&*()_+\|}{][<>.,/?`)
RETURN
ENGLISH - 49
Advertisement
Chapters
Table of Contents
