Connecting Example: Computers - Panasonic PT-CMZ50 Operating Instructions Manual

Connecting example: Computers

Computer
USB Memory
Attention
f When connecting the projector to a computer or an external device, use the power cord supplied with each device and commercially
available shielded cables.
Note
f For the HDMI cable, use an HDMI High Speed cable that conforms to the HDMI standards. In addition, when 4K image signal is to be input,
please use HDMI cable that is compatible with 4K image signal. Images may be disrupted or may not be projected when an image signal
exceeding the supported transmission speed of the HDMI cable is input.
f The <HDMI IN 1> terminal /<HDMI IN 2> terminal can be connected to an external device with the DVI-D terminal by using an HDMI/DVI
conversion cable. However, this may not function properly for some external devices, and image may not be projected.
f If you operate the projector using the computer with the resume feature (last memory), you may have to reset the resume feature to operate
the projector.
f To output signals from the <HDMI OUT> terminal, set the [PROJECTOR SETUP] menu → [HDMI OUT] to [ON].
Chapter 2 Getting Started - Connecting
Monitor
Computer
Control computer
Control computer
ENGLISH - 39