Table of Contents
Advertisement
[SECURITY] menu
On the menu screen, select [SECURITY] from the main menu, and select an item from the submenu.
Refer to "Navigating through the menu" (x page 63) for the operation of the menu screen.
f When the projector is used for the first time
Initial password: Press awsqawsq in order, and press the <ENTER> button.
Attention
f When you select the [SECURITY] menu and press the <ENTER> button, entering a password is required. Enter the preset password and
then continue operations of the [SECURITY] menu.
f When the password has been changed previously, enter the changed password, and press the <ENTER> button.
Note
f The entered password is displayed with "" mark on the screen.
f An error message is displayed on the screen when the entered password is incorrect. Re-enter the correct password.
[PASSWORD]
Sets the security password entry.
If the security password entry is enabled, the [PASSWORD] screen will be displayed and the security password is
required for the following cases.
f Connect the power plug to the outlet and turn the power on.
f Execute the [PROJECTOR SETUP] menu → [INITIALIZE ALL].
f Execute the [NETWORK] menu → [INITIALIZE].
1)
Press as to select [PASSWORD].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
Note
f This item is set to [OFF] in the factory default setting or when the [PROJECTOR SETUP] menu → [INITIALIZE ALL] is executed. Set it to
[ON] as necessary.
f Even it is set to [ON], the security password entry setting will not be effective until you turn off the power and reconnect the power plug to
the outlet. If the entered password is incorrect when the power is turned on, the operation will be restricted to the power <v/b> button.
[PASSWORD CHANGE]
Change the security password.
1)
Press as to select [PASSWORD CHANGE].
2)
Press the <ENTER> button.
f The [PASSWORD CHANGE] screen is displayed.
3)
Press asqw or number buttons (<0>-<9>) to set the password.
f Up to eight button operations can be set.
4)
Press the <ENTER> button.
5)
Re-enter the password for the confirmation.
6)
Press the <ENTER> button.
Note
f The entered password is displayed with "" mark on the screen.
f Change the password periodically and make it hard to guess.
f If numbers have been used for the security password, the security password will need to be initialized again if the remote control is lost.
Consult your dealer for the initialization method.
112 - ENGLISH
Chapter 4 Settings - [SECURITY] menu
Disables the security password entry.
Enables the security password entry.
Advertisement
Chapters
Table of Contents
