Table of Contents
Advertisement
f Check the focus at the center and periphery of the image and and make fine adjustments.
f The projected image size may change when the focus in the periphery of the image is adjusted. Check the
projected image size too when adjusting the focus in the center and periphery of the image.
5)
Press the <MENU> button, <RETURN> button, or <FOCUS> button to proceed to the initial setting.
Initial setting (display language)
Select the language to show on the screen.
After the initial setting, you can change the display language from the [LANGUAGE] menu.
1)
Press asqw to select the display language.
2)
Press the <ENTER> button to proceed to the following initial setting.
Initial setting (projector setup)
If necessary, change the setting of each item.
1)
Press as to select an item.
Item
[PROJECTION METHOD]
[SCREEN FORMAT]
[SCREEN POSITION]
[STANDBY MODE]
2)
Press qw to switch the setting.
f When all settings are completed, proceed to Step 3).
3)
Press the <ENTER> button.
f Confirm the setting value and complete the initial setting.
Setting [PROJECTION METHOD]
If the screen display is upside down or is reversed, please change the settings, refer to "Installation mode"
(x page 32). After initialization, you can change the settings from the [PROJECTOR SETUP] menu →
[PROJECTION METHOD].
1)
Press as to select the [PROJECTION METHOD].
Chapter 3 Basic Operations - Switching on/off the projector
INITIAL SETTING
中文 ( 简体 )
PLEASE SELECT LANGUAGE.
SELECT
INITIAL SETTING
PROJECTION METHOD
SCREEN FORMAT
SCREEN POSITION
STANDBY MODE
If STANDBY MODE is set to ECO,
you cannot use network functions
when the projector is standing by.
Also, you cannot use some RS-232C
SELECT
Set [PROJECTION METHOD] depending on the installation mode.
Set the aspect ratio of the screen.
Set the display position of the screen.
Set the operation mode during standby.
ENTER
AUTO
16:10
NORMAL
protocol commands.
RETURN
ENTER
Description
ENGLISH - 47
Advertisement
Chapters
Table of Contents
