Table of Contents
Advertisement
[E-mail set up] page
When there is a problem or the runtime of a luminous lamp reaches a set value, an E-mail can be sent to preset
E-mail addresses (up to two addresses).
Click [Detailed set up] → [E-mail set up].
1
[ENABLE]
Select [Enable] to use the E-mail function.
2
[SMTP SERVER NAME]
Enter the IP address or the server name of the E-mail server
(SMTP). To enter the server name, the DNS server needs to be
set up.
3
[MAIL FROM]
Enter the E-mail address of the projector. (Up to 63 characters
in single byte)
4
[MEMO]
Enter information such as the location of the projector that
notifies the sender of the E-mail. (Up to 63 characters in single
byte)
7
[E-MAIL ADDRESS 1], [E-MAIL ADDRESS 2]
Enter the E-mail address to be sent. Leave [E-MAIL ADDRESS
2] blank when two E-mail addresses are not to be used.
8
Settings of the conditions to send E-mail
Selects the conditions to send E-mail.
[MAIL CONTENTS]:
Selects either [NORMAL] or [SIMPLE].
[ERROR]:
Sends an E-mail when an error has occurred in the self-
diagnosis.
146 - ENGLISH
Chapter 5 Operation of Function - Web control function
5
[MINIMUM TIME]
Change the minimum interval for the temperature warning
E-mail. The default value is 60 minutes. In this case, another
E-mail will not be sent for 60 minutes after sending the
temperature warning E-mail even if it reaches the warning
temperature.
6
[INTAKE AIR TEMPERATURE]
Change the temperature setting for the temperature warning
mail. A temperature warning E-mail is sent when the
temperature exceeds this value.
[INTAKE AIR TEMPERATURE]:
Sends an E-mail when the air intake temperature has reached
the value set at the above field.
9
[Submit]
Updates the settings.
1
2
3
4
5
6
7
8
7
8
9
Advertisement
Chapters
Table of Contents
