Panasonic PT-CMZ50 Operating Instructions Manual page 84

Hide thumbs Also See for PT-CMZ50:
Table of Contents

Advertisement

4)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
f Proceed to Step 5) when [ON] is selected.
5)
Press the <ENTER> button.
f The [EDGE BLENDING] screen is displayed.
6)
Press as to specify the location to be adjusted.
f When joining at top: Set [UPPER] to [ON]
f When joining at bottom: Set [LOWER] to [ON]
f When joining at left: Set [LEFT] to [ON]
f When joining at right: Set [RIGHT] to [ON]
7)
Press qw to switch to [ON].
8)
Press as to select [START] or [WIDTH].
9)
Press qw to adjust the starting position or width.
10) Press as to select [MARKER].
11) Press qw to select a marker color.
f The items will switch each time you press the button.
[OFF]
[RED]
[GREEN]
[BLUE]
[CYAN]
[MAGENTA]
[YELLOW]
f A marker for image position adjustment is displayed. Make sure to set different marker colors for the
projectors to be joined. The position where the marker lines overlap for the projectors to be joined will be
the optimal point. If the marker lines cannot overlap after image position adjustment, make adjustments with
the [POSITION] menu → [SCREEN ADJUSTMENT] → [CORNER CORRECTION]/[GRID ADJUSTMENT].
Make sure to set the blending width for the projectors to be joined to the same value. Optimal joining is not
possible with projectors that have different blending widths.
12) Press as to select [BRIGHTNESS ADJUST].
13) Press the <ENTER> button.
f The [BRIGHTNESS ADJUST] screen is displayed.
f By setting [AUTO TESTPATTERN] to [ON] on the [EDGE BLENDING] screen, the black test pattern is
displayed when you enter the [BRIGHTNESS ADJUST] screen.
14) Press as to select [NON-OVERLAPPED BLACK LEVEL].
84 - ENGLISH
Chapter 4 Settings - [POSITION] menu
Sets edge blending to off.
Sets edge blending to on.
Use the setting value preset in the projector for the edge blending area.
Does not display the marker.
Displays the marker of the selected color.
The optimal point is the point at which these lines overlap.
Marker lines (left screen)
Marker lines (right screen)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pt-cmz50buPt-cmz50u

Table of Contents