[Hdmi Out]; [Initialize All] - Panasonic PT-CMZ50 Operating Instructions Manual

[POWER ON]
[POWER ON/OFF]
Note
f The connected CEC-compatible device may not support the link operation described in the manual. Not all the operations of the
CEC-compatible device are guaranteed.

[HDMI OUT]

Make settings when outputting the signals of <HDMI IN 1> / <HDMI IN 2> / <DIGITAL LINK/LAN> terminal from
the <HDMI OUT> terminal.
The [HDMI OUT] setting is synchronized with the [POSITION] menu → [MULTI IMAGE PROJECTION] → [HDMI
OUT]. The most recent setting is reflected in both items.
1) Press as to select [HDMI OUT].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
f If [ON] is selected, proceed to Step 3).
3) Press the <ENTER> button.
f The [HDMI OUT MODE] screen is displayed.
4) Press qw to switch the item.
f The items will switch each time you press the button.
[PASS THROUGH]
[SYNC TO OTHER DEVICE]

[INITIALIZE ALL]

Return various setting values to their factory default settings.
1) Press as to select [INITIALIZE ALL].
2) Press the <ENTER> button.
3) When the [INITIALIZE ALL] screen is displayed, press qw to select [OK] and then press the <ENTER>
button.
4) When the power off confirmation screen is displayed after a while, press the <ENTER> button.
f The operations except for powering off are disabled.
110 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu
Enables power-on link operation.
While the projector is in standby, if the CEC-compatible device connected to the <HDMI IN 1> terminal or
<HDMI IN 2> terminal is turned on, the projector turns on, starts projection, and switches to the input that the
linked CEC-compatible device is connected.
While the projector is in standby, if the CEC-compatible device starts playing, the projector turns on, starts
projection, and switches to the input that the linked CEC-compatible device is connected.
While the projector is turned on, if the CEC-compatible device starts playing, the projector switches to the input
that the CEC-compatible device is connected.
Power-off link operation is disabled.
Enables power-on link operation and power-off link operation.
While the projector is in standby, if the CEC-compatible device connected to the <HDMI IN 1> terminal or
<HDMI IN 2> terminal is turned on, the projector turns on, starts projection, and switches to the input that the
CEC-compatible device is connected.
While the projector is in standby, if the CEC-compatible device starts playing, the projector turns on, starts
projection, and switches to the input that the CEC-compatible device is connected.
While the projector is turned on, if the CEC-compatible device starts playing, the projector switches to the input
that the CEC-compatible device is connected.
While the projector is turned on, if the CEC-compatible device connected to the <HDMI IN 1> terminal or
<HDMI IN 2> terminal is turned off, the projector turns off and enters standby mode.
The link operations are only available when the CEC-compatible device supports the respective operations.
Disables signal output from the <HDMI OUT> terminal.
Enables signal output from the <HDMI OUT> terminal.
Select this item when outputting the signal from the <HDMI OUT> terminal based on the resolution
recommended by the projector. If the resolution recommended by the projector is not supported by
the external device, the signal may not be displayed properly.
Select this item when outputting the signal from the <HDMI OUT> terminal based on the
recommended resolution of the external device. However, if the recommended resolution of the
external device is not supported by the projector, the signal may not be displayed properly.