Table of Contents
Advertisement
f Confirm the aspect ratio of the projection screen and the image, and switch to an optimum aspect ratio from the [POSITION] menu →
[ASPECT].
Note
f If NETWORK input is selected, the image from a computer (including iPad / iPhone / iPod touch and Android device) can be transferred via
wireless LAN/wired LAN to the projector by using the Panasonic image transfer application software.
For details about the image transfer application software "Presenter Light" and "Wireless Projector", refer to the website (https://panasonic.
net/cns/projector/).
f When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the <DIGITAL LINK/
LAN> terminal, the input on the DIGITAL LINK output supported device changes each time the <DIGITAL LINK> button is pressed. The input
can also be changed using the RS-232C control command.
For twisted-pair-cable transmitters of other manufacturers, switch the input on the projector to DIGITAL LINK, and then switch the input on
the twisted-pair-cable transmitter.
For details of the RS-232C operation command, refer to "<SERIAL IN> terminal" (x page 170).
Switching the input with the control panel
The input can be switched with the <INPUT SELECT> button on the control panel
After pressing the <INPUT SELECT> button, the detailed or simple input guide is displayed.
INPUT SELECT
COMPUTER
HDMI1
HDMI2
DIGITAL LINK
MEMORY VIEWER
NETWORK
MENU
SELECT
Detailed input guide example
1)
Press the <INPUT SELECT> button on the control panel.
f The input guide is displayed.
2)
Press the <INPUT SELECT> button again.
f The input is switched every time you press the <INPUT SELECT> button.
f When the detailed input guide is displayed, you can select the input with the as buttons on the control
panel or on the remote control.
Note
f You can switch the detailed/simple input guide by setting the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] → [INPUT GUIDE].
f When the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] → [INPUT GUIDE] is set to [OFF], the input guide is not displayed.
Adjusting the focus
Adjust the focus if the image projected to the screen is not clearly displayed.
1)
Press the <FOCUS> button on the remote control or the control panel.
f The [CENTER FOCUS] adjustment screen and the focus test pattern are displayed.
f Pressing the <FUNCTION> button can hide or display the focus test pattern.
2)
Press asqw to adjust the focus at the center of projected image.
3)
Press the <ENTER> button.
f The [PERIPHERY FOCUS] adjustment screen is displayed.
4)
Press asqw to adjust the focus in the periphery of the screen.
5)
If necessary, press the <ENTER> button and repeat Step 2) to adjust the focus at the center of
projected image again.
f Check the focus at the center and periphery of the image and and make fine adjustments.
f The projected image size may change when the focus in the periphery of the image is adjusted. Check the
projected image size too when adjusting the focus in the center and periphery of the image.
Note
f It is recommended that images be projected continuously for at least 30 minutes before the focus is adjusted.
Chapter 3 Basic Operations - Projecting
1024 x 768
Simple input guide example
ENGLISH - 53
Advertisement
Chapters
Table of Contents
