Panasonic PT-CMZ50 Operating Instructions Manual page 26

Attention
f Do not drop the remote control.
f Avoid contact with liquids or moisture.
f Do not attempt to modify or disassemble the remote control.
f Please observe the following contents that are described on the back of the remote control unit (see the picture below).
g Do not use a new battery together with an old battery.
g Do not use unspecified batteries.
g Make sure the polarities (+ and -) are correct when inserting the batteries.
In addition, please read the contents that are related to batteries in the "Read this first!".
Note
f The remote control can be used within a distance of about 6 m (19'8-7/32") if pointed directly at the remote control signal receiver. The
remote control can control within angles as shown in the following figure, but the effective control range may be reduced.
f If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate correctly.
f When the remote control signal receiver is lit with a fluorescent light or other strong light source, the projector may become inoperative. Set
the projector as far from the luminous source as possible.
f The power indicator <ON (G)/STANDBY (R)> will blink if the projector receives a remote control signal.
26 - ENGLISH
Chapter 1 Preparation - About your projector
Caution label at the back of the remote control
30°
30°
60°
90°
15°