Panasonic PT-CMZ50 Operating Instructions Manual page 85

15) Press the <ENTER> button.
f The [NON-OVERLAPPED BLACK LEVEL] screen is displayed.
f [RED], [GREEN], and [BLUE] can be adjusted individually if [INTERLOCKED] is set to [OFF].
16) Press as to select an item, and press qw to adjust the setting.
f Once the adjustment is completed, press the <MENU> button to return to the [BRIGHTNESS ADJUST]
screen.
17) Press as to select [SIDE SELECT] in [BLACK BORDER ADJUST], and press qw to select [UPPER],
[LOWER], [LEFT], or [RIGHT].
18) Press as to select [POINTS SELECT], and press qw to set the number of points for adjustment.
[3]
[11]
f Make sure to set [POINTS SELECT] to the same number of points when adjusting both the upper border
and the lower border or both the left border and the right border.
19) Press as to select [EXECUTE].
20) Press the <ENTER> button.
f The screen switches to the point selection mode.
21) Press as or qw to select the point.
22) Press the <ENTER> button.
f The point is confirmed, and the screen switches to the adjustment mode. In the adjustment mode, all the
points are hidden.
23) Press asqw to adjust the position of the selected point.
f By adjusting the position of the points, the border will become less visible.
f To continuously adjust the position of the other points, press the <RETURN> button to return to Step 21).
f To initialize the positions of all the points, execute [INITIALIZE] in [BLACK BORDER ADJUST].
f Once the adjustment is completed, press the <RETURN> button twice to return to the [BRIGHTNESS
ADJUST] screen.
24) Press as to select [UPPER], [LOWER], [LEFT], or [RIGHT] for [OVERLAPPED BLACK LEVEL].
25) Press the <ENTER> button.
f The [OVERLAPPED BLACK LEVEL] screen is displayed.
f [RED], [GREEN], and [BLUE] can be adjusted individually if [INTERLOCKED] is set to [OFF].
26) Press as to select an item, and press qw to adjust the setting.
f Once the adjustment is completed, press the <MENU> button twice to return to the [EDGE BLENDING]
screen.
27) Press as to select [BLENDING CURVE], and press qw to switch to [ON].
28) Press the <ENTER> button.
f The [BLENDING CURVE] screen is displayed.
29) Press as to select [LEVEL], and press qw to adjust the brightness of the overlapping area.
f By setting [TEST PATTERN] on the [BLENDING CURVE] screen to an item other than [OFF], you can
confirm the edge blending status using the displayed test pattern.
Chapter 4 Settings - [POSITION] menu
The border can be adjusted with 3 points.
The border can be adjusted with 11 points.
ENGLISH - 85