Table of Contents
Advertisement
Mounting
3.2.1 Removal From the Panel
8
When the controller is mounted in a panel cutout, the easiest way to remove it is to
depress the retainer springs from the rear and press the controller out of the cutout
(see Figure 7, page 7). If there is no access to the rear of the controller, it can be
tilted out of the cutout by inserting a screwdriver in the two recesses provided at
both ends of the unit. Then carefully turn the screwdriver to twist the controller
out of the panel.
EI.65.D4.02
Advertisement
Table of Contents
