Motion Alarm; Motion Configuration; Motion Alarm Handling Configuration - Speco HRLN User Manual

Alarm Management
To set the duration time of the message box, please see 9.5.3 Display for details.
E-mail: if enabled, the system will send an e-mail when the sensor alarm is triggered. Before you enable the email, please configure the recipient's
e-mail address first (see 11.1.5 E-mail Configuration for details).

9.2 Motion Alarm

Motion Alarm: when the motion object appears in the specified area, it will trigger the alarm. You should enable the motion of each camera first
and then set the alarm handling of the camera to complete the whole configuration of the motion alarm.

9.2.1 Motion Configuration

① Click StartSettingsCameraMotion to go to the following interface.
② Select the camera, enable the motion and set the sensitivity and duration of the camera.
Sensitivity: the higher the value is, the more sensitive it is to motion. You should adjust the value according to the practical conditions since the
sensitivity is influenced by color and time (day or night).
Duration: The interval time between the adjacent motion detections. For instance, if the duration time is set to 10 seconds, once the system
detects a motion, it will go to alarm status and would not detect any other motion (specific to camera) for 10 seconds. If there is further motion
detected during this period, it will be considered as continuous movement; otherwise, it will be considered a single motion.
③ Drag on the camera image to set the motion area. Click "All" to set the whole camera image as the motion area. Click "Reverse" to swap the
motion area and the non-motion area. Click "Clear" to clear all the motion areas.
④ Click "Apply" to save the settings. Click "Processing Mode" to go to the alarm handling configuration interface of the motion alarm.

9.2.2 Motion Alarm Handling Configuration

① Click StartSettingsAlarmMotion Alarm to go to the following interface.
56
DVR User Manual