Image Settings; Mask Settings - Speco N64NR24TB User Manual

Live View
Introduction

5.3.2 Image Settings

Click StartSettingsCameraImageImage Settings to go to the following interface. Select the camera and then
set the brightness, contrast, saturation and hue of the camera. Click "Advanced" button or
the right side of the interface to pop up "Image Adjust" interface and then set the relevant setting items. Please refer
to 5. 4.5 Image Adjustment
You can click "Default" to restore the image settings to the default factory settings.

5.3.3 Mask Settings

Some areas of the image can be masked for privacy. Up to four mask areas can be set for each camera. Click
StartSettingsCameraImageMask Settings to go to the interface as shown below. Select the camera and enable
the mask. Click "Draw" button and then drag the mouse on the image area to set the mask area; click "Delete" button
to delete the mask areas; click "Apply" to save the settings.
for detailed introductions of these items.
28
NVR User Manual
in the camera list on