Backside; Installation; Set Up And Operation - SHOWTEC Cameleon Flood 11CW V1 Manual

Cameleon Flood 11CW

Backside

Fig. 02
03) Special 3-pin power cable OUT IP-65
04) Special 3-pin power cable IN IP-65

Installation

Remove all packing materials from the Cameleon Flood 11CW. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
This device is a plug- and- play device. It is easy to connect the device to a proper main power supply.
First connect the included 1x Schuko to 3-pins Power cable to the special power connector IN (04) from
the device, see fig.03 on page 9. Then connect the included 1x Schuko to 3-pins Power cable into a
proper electric power supply socket. With the special cable OUT (03) it's possible to link several
Cameleon Floods with each other.
Ordercode: 42687
8