Table of Contents
Advertisement
DiSEqC 1.0
DiSEqC 1.1
Motor
note:
There is also the possibility to change (add, edit or delete) a satellite or transponder by pressing
search for channels: Auto search, Manual search, Blind scan and Network search. Press the bLue button
to display the Scan menu and press OK to confirm.
7.6 electronic Programme Guide (ePG)
The Electronic Programme Guide (EPG) shows programme schedules and information for current
programmes and coming programmes up to the 7 next days. Press ePG button on remote to open
the EPG in viewing mode. To change to other channel, press the ReD and GReen buttons. Press
tupq to navigate in the EPG menu. Press OK to get detailed information about the programme.
Press the bLue Timer button to set a reminder for a programme or to programme a recording.
8.0 TROubLesHOOTinG
There may be many reasons that affect the correct operation of your Android receiver. If the receiver
does not work as you expect, please follow the steps outlined below. If after performing these
operations the receiver still does not work well, contact your dealer or service centre in your area or
write an email to our support via our website www.strong.tv.
If the DTV part shows problems with reception, first check if all cables and connectors still are in good
condition. Check whether your dish/antenna still is fixed well and pointed optimally to the satellite
of your choice. Check whether the satellite settings in the menus are still correct. If all is OK, you can
reset the unit back to the factory settings and try to install again. Refer to chapter 7.3.7 of this user
manual.
If you experience problems in the Android part, first check whether it is caused by an application. Try
to clear the data or remove the app and check if this solves the problem. Please enter Settings – Apps
-- (select the app) -- Clear data and then return to the menu and test if all works again.
If not successful you can reset the receiver back to the factory settings and try to install it again. Refer
to chapter 6.7.2 of this user manual.
warning:
20
If you are using a DiSEqC 1.0 switch to switch between 2, 3 or 4 satellites,
setup your port to the satellite you have selected above.
If you are using a DiSEqC 1.1 to switch between 5 to 16 satellites, setup your
port to the satellite you've selected above.
If you are using a motor drive to move between satellites, setup the motor
drive by using DiSEqC 1.2 or Goto X protocols.
We strongly advise to ask your local installer to help install motor and
settings.
Do not open the receiver cover. This action will damage the warranty seals
and warranty repairs will be denied.
PART 1
i
and
Advertisement
Table of Contents
