Troubleshooting - Strong SRT 8115 User Manual

PART 1 • English
WARnIng!
Press ok to proceed, select FAT or Cancel, or press EXIT to leave without formatting.
noTE:
Press EXIT to leave this menu.
7.6.3 dvR Setting
This menu allows you to configure settings for Timeshift, recording and playback.
Select DVR Setting in the Media menu and press ok to enter.
Use pq to move the highlight and tu to change settings.
Timeshift:
Step to:
Time Shift to Record:
PS Record:
Press EXIT to leave this menu.
7.6.4 Remove uSb device safely
Select Remove USB device safely from the tools menu and press ok. The receiver will display a
message indicating that you can safely remove your storage device from the receiver.
noTE:

8.0 TRoublEShooTIng

There may be various reasons for abnormal operation of the receiver. Check the receiver according to
the procedures shown below. If the receiver does not work properly after checking it, please contact
your dealer or the local Service Hotline. Do NOT try to open or disassemble the receiver. It may cause
a dangerous situation and warranty will be void.
Formatting will permanently delete ALL data stored on the connected
device. Please make a backup copy of all data you wish to keep before
entering the HDD Format menu. STRONG cannot be held responsible for
loss of data from USB devices used with this receiver.
It is possible to use USB storage devices already formatted in NTFS.
Select between Auto, Pause or Off. When Timeshift is set to Auto it will
automatically start every time after tuning to a channel. When Timeshift is set
to Pause it will start only after pressing the YElloW/2 button. Select Off to
deactivate Timeshift.
30 sec to 30 min. Set the time step you like to jump forward by pressing 4
during playback of recorded files. This will only work when the info banner is
displayed on screen. If it is not, press Info.
If set to On the timeshifted part will be included in your recording when you
start to record the current programme.
Select between On or Off. When Off is selected, recordings will also
include subtitles and Teletext (when available). Record to PS mode On
allows recordings without these extras which will need less space on your
USB device.
After performing this function, the USB device is no longer accessible from
your receiver. To gain access to your storage device again, re- insert it or
switch the receiver to standby and on again.
19