Table of Contents
Advertisement
WARNING:
Formatting will permanently delete ALL data stored on the connected device. Please make
a backup copy of all data you wish to keep before entering the HDD Format menu. STRONG
cannot be held responsible for loss of data from USB devices used with this receiver.
NOTE:
It is possible to use USB storage devices already formatted in NTFS.
Press EXIT to leave this menu.
7.5.3 DVR Setting*
This menu allows you to configure settings for Timeshift, recording and playback.
Select DVR Setting in the Media menu and press OK to enter.
Use pq to move the highlight and t u to change settings.
Timeshift:
Select between Auto, Pause or Off. When Timeshift is set to Auto it will automatically start every
time after tuning to a channel. When Timeshift is set to Pause it will start only after pressing the
YELLOW/[2 button. Select Off to deactivate Timeshift.
Step to:
30 sec to 30 min. Set the time step you like to jump forward to by pressing 4 during playback
of recorded files. This only works when the info banner is displayed on screen. If it is not, press
INFO.
Time Shift to Record:
If set to On the timeshifted part will be included in your recording when you start to record the
current programme.
PS Record:
Select between On or Off. When Off is selected, recordings will also include subtitles and
Teletext (when available). Record to PS mode On allows recordings without these extras and
will need less space on your USB device.
Press EXIT to leave this menu.
* This user manual describes the full functionality including the recording function and may not be applicable if the software for recording via
USB has not yet been installed.
7.5.4 Remove USB device safely
Select Remove USB device safely from the tools menu and press OK. The receiver will display a message indicating that
you can safely remove your storage device from the receiver.
NOTE:
After performing this function, the USB device is no longer accessible from your receiver. To
gain access to your storage device again, re-insert it or switch the receiver to standby and on
again.
8.0 TROUBLESHOOTING
There may be various reasons for abnormal operation of the receiver. Check the receiver according to the procedures
shown below. If the receiver does not work properly after checking it, please contact your dealer or the local Service
Hotline. Do NOT try to open or disassemble the receiver. It may cause a dangerous situation and warranty will be void.
Problem
LED indicator not lit
No signal found
No picture or sound on TV or
amplifier
Possible cause
Mains lead unplugged
Cable input is disconnected
HDMI or SCART is not selected on your
TV or amplifier or the unit is set to higher
resolution as the TV supports.
TV/amplifier is not switched on
What to do
Check mains plug
Check cable lead
Check with dealer
Switch to correct TV/amplifier input
Select lower resolution on receiver
Switch TV/amplifier on.
Check if S/PDIF connection is used.
17
Advertisement
Table of Contents
