Table of Contents
Advertisement
OPERATING
Start pre-conditions
Bar loading magazine MBL22‑8, MBL24‑6, MBL32‑6, MBL40‑6, MBL40‑8
INDEX Multi spindle turning machines Control system C200-sl
DIM063EN - 2021-09-27
Hoisting belt settings
(only relevant in case of bundle loading units)
Navigation: B asic screen/information → User settings→ Horizontal sub-screen
"General user settings"
⊠
Hoisting belts ‑ top position
Usually, the hoisting belts are mounted at the bottom position
arms which is intended for the attachment. Round bars will roll into the direction
of the separating unit during the lifting procedure. Multi-sided bars, however, will
not roll, they have to slide. However, sometimes, the bars will not slide due to the
fact that the inclination of the belts are not steep enough for said sliding purpose.
In such cases, the belts must therefore be attached at the top position
arms in order to achieve a steeper inclination of the belts in lifted-up condition.
In case of new machines, INDEX attaches the belts at the top position right away
during the INDEX assembly process.
①
of the bundle
②
of the
69
Advertisement
Table of Contents
