Table of Contents
Advertisement
D220
- Replace belts and check belt tension
Orientation
Requirement
Procedure
114
Use only the original belts according to the spare or wear parts list.
After replacing a drive belt, be sure to observe the values (Hz)
specified in the table below for the belt tension of the respective axis.
A frequency meter is required for testing.
Also the reference point may need to be checked or adjusted.
Setting values in Hertz (Hz) for belt tension
1.
Uncontrolled movements of axes or machine components.
Severe cut and crush injuries.
Caution
Secure all axes or components against uncontrolled movements
during maintenance or repair work.
Move the tool slides to a suitable position.
2. Replace X2 belt.
3. Replace the belt of the work area door drive.
Maintenance Summary - 4.000 Operating hours
G300.2 G320.2 G400.2 G420 G500.2 G520
Maintenance Instructions
DIE147EN - 17.08.2022
Advertisement
Table of Contents
