Table of Contents
Advertisement
SAfETy INfORmATION
Situational safety information
Spot-drilling unit
24
Situational safety information
Transport and packing
• The hydraulic system must be depressurized before transport.
The oil reservoir must be evacuated before transport.
• The bar magazine must not be lifted at the cowling.
• Apart from that, the instructions in document "Safety instructions for CNC turn-
ing machines" shall apply.
Assembly and installation
Refer to document "Safety instructions for CNC turning machines", please.
Commissioning (set‑up mode)
Set-up mode with the machining area door open allows movements at reduced
speeds, which may pose a certain risk.
To reduce said risk, please heed the instructions in the respective section of docu-
ment "Safety instructions for CNC turning machines".
Operation (production mode)
During the production process, the bar loading magazine needs not to be super-
vised. The non-supervised operation of the bar loading magazine, however, re-
quires (normally prior to operation) detailed analysis and evaluation of the planned
production process with respect to additional risks and dangers which may arise
from the non-supervision of the magazine.
The specified speeds must be observed.
Depending on the properties of the material bars, it may however be necessary to
reduce the speed.
Otherwise, the instructions of document "Safety instructions for CNC turning ma-
chines" shall apply.
Bar loading magazine MBL22‑8, MBL24‑6, MBL32‑6, MBL40‑6, MBL40‑8
INDEX Multi spindle turning machines Control system C200-sl
DIM063EN - 2021-09-27
Advertisement
Table of Contents
