Work Stations At The Bar Loading Magazine - Index MBL22-8 Series Operating Instructions Manual

DESIGN AND fUNCTIONS
General description
Bar loading magazine MBL22‑8, MBL24‑6, MBL32‑6, MBL40‑6, MBL40‑8
INDEX Multi spindle turning machines Control system C200-sl
DIM063EN - 2021-09-27

Work stations at the bar loading magazine

The following work stations are planned at the bar loading magazine:
2
①
Loading unit
Here, you load the bars. Depending on the version of the loading unit, the bars are
being loaded manually or by means of a crane.
In case you use a rack loader unit, you also have to carry out adjustment work.
②
Spot‑drilling unit
At the spot-drilling unit, you exchange drills and collet and you discharge the chip
container. In addition, you have to carry out adjustments for adaptation of the unit
to the bar diameter.
③
Drum
Here, you exchange the half bearings in the guidance channels as well as the slid-
ers according to the bar diameter.
③
Bar lift
Adjustment work for the adaptation of the lift to the respective bar diameter
③
Remnant container
Discharging the remnant container
For detailed information, refer to the chapters "Operation, Loading and Set-up",
please.
1
3
33