Index MS32-6.3 Operating Instructions Manual page 96

92
9.
Example: MS32-6.3 window pane of work area door 6 (Fig. 10)
Reinstall the front cover or front pane/design pane (a). There are 2 set screws
(g) in the upper area of the work area door to help with installation. The design
pane (a) can be hooked onto these set screws. The set screws can be used to
adjust the height of the pane if required. The design pane must nevertheless
remain secured against falling down until all screws (M6 – 9x) along the contour
have been tightened again on both sides (see Fig. 10).
10.
Example: MS32-6.3 window pane of work area door 7 (Fig. 11)
1 Upper groove nut
2 Lower groove nut
3 Trolley
h Vertical adjustment
q Horizontal adjustment
Align work area door. (Vertical and horizontal adjustment at the bottom)
After the design pane has been installed, the work area door can be realigned if
necessary. There are several adjustment options in both the lower and upper
area of the work area door for this purpose. Vertical adjustment (h): 2 trolleys
(3) are located in the lower area of the work area door . Each of them is
fastened to the work area door with 2 groove nuts. Loosen the upper groove nut
(1) and adjust vertically using the groove nut (2). Then retighten the upper
groove nut. Horizontal adjustment at the bottom: Loosen the groove nut (1)
again and perform horizontal adjustment in the area of the slotted hole (q).
Then retighten the upper groove nut.
Maintenance Summary - 8 Years
Maintenance Instructions
DIM105EN - 26.04.2022
MS32-6.3