Index MS32-6.3 Operating Instructions Manual page 46

42
2.
Example: Installation tool (Hainbuch)
Example: Remove clamping element holder and base body
Remove 6 screws (4) and remove clamping element holder (2) (see also AM...
Removing clamping element holder). Remove base body (1) using the
installation tool.
3.
Base body (1) and clamping tube (6) are bonded together.
(LOCTITE
Remove base body (1) with clamping tube (6) from the spindle and clean.
4. Check clamping tube (6), base body (1), and Glyd ring for damage and wear,
replace if necessary.
5. Grease collet (oil-resistant grease)
6. Screw base body (1) into the clamping tube (6) and into the spindle again using
the installation tool. Use the installation tool for this purpose.
7.
Maintenance Summary - Care activities
)
®
Maintenance Instructions
MS32-6.3
DIM105EN - 26.04.2022