Index MS32-6.3 Operating Instructions Manual page 43

Maintenance Summary - Care activities
Procedure
Maintenance Instructions
MS32-6.3
DIM105EN - 26.04.2022
1. Deactivate spindle control on the machine controller.
2.
Mounting in adjacent holes will damage the encoder
system of the respective spindle, requiring repair and
readjustment.
Caution
Always make be sure to mount the locking pin only at the points/
holes marked in red on the respective spindle.
Turn the spindles by hand until the locking pin can be mounted.
3. Be sure to remove the spindle lock (device/locking pin) after finishing
the work.
39