Table of Contents
Advertisement
Maintenance Summary - 8 Years
JM020
- Replace the window pane
Orientation
Requirement
Maintenance Instructions
MS32-6.3
DIM105EN - 26.04.2022
For safety reasons, it is recommended to obtain the window pane
directly from the machine manufacturer or its country representative.
The window pane consists of 3 panes. The inner pane made of tempered glass, a
central pane made of polycarbonate, and an outer pane made of polymethyl
methacrylate (PMMA). The inner pane is relatively resistant to chemical substances.
It can be cleaned with any commercially available cleaning agents. Only the center
pane is essential for the impact resistance of the window pane.
The polycarbonate panes are subject to natural aging and therefore must be
subjected to regular visual inspection. Through contact with cooling lubricant, the
aging process is accelerated even further.
Example: MS32-6.3 window pane of work area door 1 (Fig. 1)
a
Outer design pane (PMMA)
m
Center pane (polycarbonate)
i
Inner pane (glass)
s
Seal/sealant
A sealant is used at the factory to seal the new window pane. Either Silicone 1200
of General Electric or Terostat MS 930 of Teroson. If other sealing compounds
than those described here are to be used, the equivalence must be confirmed in
writing by the manufacturer.
85
Advertisement
Table of Contents
