Index MS32-6.3 Operating Instructions Manual page 27

Maintenance Summary - Care activities
Procedure
Maintenance Instructions
MS32-6.3
DIM105EN - 26.04.2022
1.
Chips and projecting tools in the work area.
Cuts.
Caution
Use of personal protective equipment such as safety goggles
and gloves, and appropriate tools.
Remove chips from the work area.
2. Chip accumulation particularly in the area of thetool carriers and the work area
door.
3. Flush work area with cooling lubricant.
4. Wipe clean with rags.
5. Apply an oil film to bare metal plates.
6. Check plates for damage, repair or replace if necessary.
7. Cleaning of chip conveyor, vacuum rotation filter and clean tank. For these
containers/tanks, special attention must be paid to cleaning the
respective corners of these containers. Experience has shown that this
is where most of the debris settles.
23