KYMCO NEXXON 50 Service Manual page 164

14
. FRAME COVER
LEG SHIELD REMOVAL
Remove the front center cover
Remove the leg shield bolt.
Remove the ignition switch decorative ring
Remove the leg shield.
The installation sequence is the reverse of
remove
FRONT FENDER REMOVAL
Remove the four bolts attaching the front
fender A and remove the front fender.
Remove the three bolts attaching the front
fender B and remove the front fender.
The installation sequence is the reverse of
remove
＊
During removal, do not pull the joint
claws forcedly to avoid damage.
When installing, be sure to connect the
seat lock wire.
EXHAUST MUFFLER REMOVAL
Remove the two exhaust muffler joint lock
nuts.
Remove the two exhaust muffler lock bolts.
Remove the exhaust muffler.
Remove the exhaust muffler joint packing
collar.
When installing, first install the exhaust
muffler packing collar and then install the
exhaust muffler.
First install and tighten the exhaust muffler
joint lock nuts. Then, install and tighten
the exhaust muffler lock bolts.
Torques:
Exhaust muffler lock bolt: 3.0~3.6kgf-m
Exhaust muffler joint lock nut: 1.0~1.4kgf-m
＊
Be sure to install a new exhaust muffler
packing collar.
Bolts
Leg Shield
Bolts
Front Fender A
Joint Lock Nut
Lock
NEXXON 50
Decorative
Front Center Cover
Bolts
Front Fender B
Bolts
14-6
Ring