KYMCO NEXXON 50 Service Manual page 119

11
. FRONT WHEEL/SUSPENSION/
STEERING
NEXXON 50
Nut
Bolt
Remove the handlebar lock nut to remove
the handlebar.
Handlebar
Tab/Groove
INSTALLATION
Install the handlebar, aligning the tabs of the
handlebar with the grooves in the steering
stem.
Install and tighten the handlebar lock nut.
Torque: 4.5~5.0kg-m
Hole
When installing the right and left handlebar
switch housings, align the pin on the housing
with the hole in the handlebar. Tighten the
two switch housing screws.
Bolts Pin
When installing the master cylinder align the
tab on the holder with the hole in the
handlebar with the holder "UP" mark facing
up.
First tighten the upper bolt and then the
lower bolt.
Torque: 1.0～1.4kg-m
"UP" Mark
11-5