Troubleshooting; Transportation And Storage - Tecnosystemi PICO CLEAN WI ACD100025 User Manual

TROUBLESHOOTING

The fan does not start
when the recovery unit is
turned on.
Switch is automatically
activated after turning on.
Insufficient air flow

TRANSPORTATION AND STORAGE

The recovery unit must be put in the original packaging in a ventilated area at a temperature
ranging between +10°C and +40°C.
The air must not contain potentially aggressive vapours or chemical mixtures that might cause
corrosion or compromise the integrity of the connections.
For handling, use only adequate lifting equipment, in order to prevent damage to the fan following
falls or excessive shaking. Follow the applicable regulations for transportation according to the
type of load.
The recovery unit can be transported with any means, provided that adequate protection against
atmospheric agents and mechanical damages is ensured. Avoid jolts and collisions during
transportation and handling operations.
36
Air Control System
Instruments &
Ventilation
Tools
Solutions
Possible causes
Accessories
For Heating
No power supply.
The motor is blocked, the
impeller is blocked.
Overcurrent due to
a short-circuit in the
electrical circuit.
Speed set low.
The filter, the fan or the
exchanger are dirty.
Multi - Zone
Management of faults
Check that the recovery unit
is correctly connected to the
mains supply and connect it, if
necessary.
Turn off the recovery unit. Find
the cause of the motor blockage
and unblock the fan. Clean the
blades. Restart the fan.
Turn off the recovery unit.
Contact customer service.
Set a higher speed.
Clean or replace the filter, clean
the fan and the regenerator.
For the regenerator and filter
maintenance, please refer to
page 47.