Commands
Parameter range
[read-only]: 1 - 8
Default
N/A
Bytes returned
1
The following AT commands are firmware commands.
HS (Hardware Series)
Read the device's hardware series number.
Parameter range
N/A
Default
0x0A00 - set in the firmware
MAC/PHY commands
The following AT commands are MAC/PHY commands.
AM (Auto-set MY)
Sets the MY (Source Address) parameter from the factory-set serial number of the device. The
address consists of bits 29, 28 and 13-0 of the serial number, in that order.
Sending AM displays the address.
Binary command
0x41 (65 decimal)
Parameter range
N/A
Default
N/A
Bytes returned
N/A
DT (Destination Address)
Sets or displays the networking address of a device. The devices use three filtration layers:
Vendor ID Number (ID)
n
Channel (HP)
n
Destination Address (DT)
n
XBee®/XBee-PRO XTend Compatible (XTC) RF Module User Guide
MAC/PHY commands
50