Replacing The Saw Bar - Hakki Pilke 38 Pro PTO Instructions Manual

10. Fine-tune the tension of the saw chain by
loosening bolts A (Figure 27b) and turning
adjustment screw B in the open or close direction
to loosen or tension the chain. A new chain might
stretch considerably during first hours of use.. In
this case, you may have to tension the chain
manually.

5.1.2. Replacing the saw bar

Replace the saw bar as follows:
1. Remove the saw chain according to steps 1–6
in Section 5.1.1.
2. Remove the bar bolts (2 pcs) and remove
bar fastening plate A.
3. Remove the saw bar from the groove.
4. Place the new flange against gear wheel B,
twist it into the groove and loosely attach the
flange bolts and fastening plate A.
5. Install and tighten the blade chain according
to steps 7–9 in Section 5.1.1.
Hakki Pilke 38 Pro
26 / 40
Translation
Figure 27b.
Figure 28.
Version 3