Ftp Auto Upgrade - Baicells EG3015M-M30-HP Configuration Manual

Table of Contents

Figure 3-46 WEB Setting

Table 3-6 WEB Setting

Field Name

Description

HTTP

Select the check box next to Enable to log in to an HTTP Web

address

HTTPPort

Enter the HTTP port number to be used. Range is 80 to 65,535.

Default is port 80.

Note: Port cannot be set to 8080. Because 8080 is already occupied by

the module port number.

HTTPS

Select the check box next to Enable to log in to an HTTPS Web

address

Redirect HTTPS

Select the check box to allow HTTP addresses to be redirected to

more secure HTTPS addresses

Allow HTTPS

Select the check box next to enable log in to an HTTPS Web address

from the WAN

HTTPSPort

Enter the HTTPS port number to be used. Range is 80 to 65,535.

Default is port 80.

Note: Port cannot be set to 8081. Because 8081 is already occupied by

the module port number.

3.6.5 FTP Auto Upgrade

The FTP Auto Upgrade feature is used for over-the-air (OTA) upgrades. The CPE will

Table of Contents