Menu Barcode Security Settings; Set Custom Defaults; Reset The Custom Defaults - Honeywell Xenon XP 195 Series User Manual

Menu Barcode Security Settings

Honeywell scanners are programmed by scanning menu barcodes or by sending
serial commands to the scanner. If you want to restrict the ability to scan menu
codes, you can use the Menu Barcode Security settings. Contact the nearest
technical support office (see
information.

Set Custom Defaults

You have the ability to create a set of menu commands as your own, custom
defaults. To do so, scan the Set Custom Defaults barcode below before scanning
the menu commands for your custom defaults. If a menu command requires
scanning numeric codes from the
then a Save code, that entire sequence will be saved to your custom defaults. When
you have entered all the commands you want to save for your custom defaults,
scan the Save Custom Defaults barcode.
Note: When using a cordless system, the Custom Defaults settings apply to all workgroups.
Scanning the Save Defaults barcode also causes both the scanner and the base or
Access Point to perform a reset and become unlinked. The scanner must be placed in
its base to re-establish the link before any setup codes are entered. If using an Access
Point, the linking barcode must be scanned. See
beginning on page 41 for additional information.
You may have a series of custom settings and want to correct a single setting. To do
so, just scan the new setting to overwrite the old one. For example, if you had
previously saved the setting for Beeper Volume at Low to your custom defaults,
and decide you want the beeper volume set to High, just scan the Set Custom
Defaults barcode, then scan the Beeper Volume High menu code, and then Save
Custom Defaults. The rest of the custom defaults will remain, but the beeper
volume setting will be updated.

Reset the Custom Defaults

If you want the custom default settings restored to your scanner, scan the Activate
Custom Defaults barcode below. This is the recommended default barcode for
most users. It resets the scanner to the custom default settings. If there are no
Xenon XP User Guide
Set Custom Defaults
Technical Assistance
Programming Chart,
Cordless System Operation
on page xvii) for further
beginning on page 311,
Save Custom Defaults
13