Serial Trigger; Presentation Mode - Honeywell Xenon XP 195 Series User Manual

Serial Trigger

You can activate the scanner either by pressing the trigger, or using a serial trigger
command (see
mode in order to use serial triggering. Refer to
Serial
until a barcode has been read or until the deactivate command is sent. The scanner
can also be set to turn itself off after a specified time has elapsed (see
Out, which follows).
Read Time-Out
Use this selection to set a time-out (in milliseconds) of the scanner's trigger when
using serial commands to trigger the scanner. Once the scanner has timed out, you
can activate the scanner either by pressing the trigger or using a serial trigger
command. After scanning the Read Time-Out barcode, set the time-out duration
(from 0-300,000 milliseconds) by scanning digits from the
beginning on page 311, then Save. Default = 30,000 ms.

Presentation Mode

Presentation Mode uses ambient light and scanner illumination to detect
barcodes. When in Presentation Mode, the LEDs remain dim until a barcode is
presented to the scanner, then the aimer turns on and the LEDs turn up to read the
code. If the light level in the room is not high enough, Presentation Mode may not
work properly.
Note: If you are using a cordless charge base in Presentation Mode, the battery will not
charge unless the power supply is plugged into the base's auxiliary power port.
Scan the following barcode to program your scanner for Presentation Mode.
Xenon XP User Guide
Trigger Commands
(page 18) for further information. When in serial mode, the scanner scans
on page 242). You must be in a serial interface
RS232 Serial Port
Read Time-Out
Presentation Mode
(page 16) or USB
Read Time-
Programming Chart,
89