Table of Contents
Advertisement
base and to set the alarm duration, scan the appropriate barcode below and then
set the time-out duration (from 0-3000 seconds) by scanning digits on the
Programming Chart,
Note: The Access Point does not have a base alarm.
Note: If you are out of range when you scan a barcode, you will receive an error tone even if
you do not have the alarm set. You receive the error tone because the data could not
be sent to the base or Access Point or the host.
Alarm Sound Type
You may change the alarm type for the scanner or base by scanning the
appropriate barcode below and then scanning a digit (0-7) barcode from the
Programming Chart,
The sounds are as follows:
Setting
0
1
2
3
4
5
6
7
Xenon XP User Guide
beginning on page 311, then Save. Default = 0 sec (no alarm).
Base Alarm Duration
beginning on page 311, then Save. Default = 0.
Sound
3 long beeps, medium pitch
3 long beeps, high pitch
4 short beeps, medium pitch
4 short beeps, high pitch
single chirps, medium pitch
2 chirps, then 1 chirp, medium pitch
single chirps, high pitch
2 chirps, then 1 chirp, high pitch
Base Alarm Type
Scanner Alarm Duration
Scanner Alarm Type
59
Advertisement
Table of Contents
