Streaming Presentation In-Stand; Hands Free Time-Out; Reread Delay - Honeywell Xenon XP 195 Series User Manual

Streaming Presentation In-Stand

This option is available when using
program a specific Streaming Presentation Mode for in-stand scanning, and a
Manual Trigger mode for out-of-stand scanning. To do this, you must first scan the
preferred Streaming Presentation mode (Normal or Enhanced), then scan the
Manual Trigger mode (Normal or Enhanced) you want to use.

Hands Free Time-Out

The Scan Stand and Presentation Modes are referred to as "hands free" modes. If
the scanner's trigger is pulled when using a hands free mode, the scanner changes
to manual trigger mode. You can set the time the scanner should remain in manual
trigger mode by setting the Hands Free Time-Out. Once the time-out value is
reached, (if there have been no further trigger pulls) the scanner reverts to the
original hands free mode.
Scan the Hands Free Time-Out barcode, then scan the time-out duration (from 0-
300,000 milliseconds) from the
Save. Default = 5,000 ms.

Reread Delay

This sets the time period before the scanner can read the same barcode a second
time. Setting a reread delay protects against accidental rereads of the same
barcode. Longer delays are effective in minimizing accidental rereads. Use shorter
delays in applications where repetitive barcode scanning is required. Reread Delay
only works when in a
Xenon XP User Guide
Presentation Mode
Short (500 ms)
Long (1000 ms)
In-Stand Sensor
Programming Chart,
Hands Free Time-Out
(see page 89). Default = Medium.
Mode, page 92. You may
beginning on page 311, then
* Medium (750 ms)
95