Host Ack Timeout; Host Ack Responses - Honeywell Xenon XP 195 Series User Manual

Host ACK Timeout

You can set a timeout for the length of time the scanner waits for a valid escape
command when using Host Acknowledgment Mode. Set the length (in seconds) for
a timeout by scanning the following barcode, then setting the timeout (from 1-90
seconds) by scanning digits from the
then Save. Default = 10.

Host ACK Responses

Command
[ESC] a,
[ESC] b,
[ESC] 1,
[ESC] 2,
[ESC] 3,
[ESC] 4,
[ESC] 5,
[ESC] 6,
[ESC] 7,
[ESC] 8,[ESC] 8,
80
Programming Chart,
Host ACK Timeout
Action
Double beeps to indicate a successful menu change was made.
Razz or error tone to indicate a menu change was unsuccessful.
The green LED illuminates for 135 milliseconds followed by a pause.
The green LED illuminates for 2 seconds followed by a pause.
The green LED illuminates for 5 seconds followed by a pause.
Emits a beep at a low pitch.
Emits a beep at a medium pitch.
Emits a beep at a high pitch.
Beeps to indicate a successful decode and communication to host.
Razz or error tone to indicate a decode/communication to host was
unsuccessful.
beginning on page 311,
Xenon XP User Guide