Deactivation Character
This sets the character used to terminate scanning when using Character Deactivation Mode. On the
Chart (Code Page
1252), page A-3, find the hex value that represents the character you want to use to terminate scanning.
Scan the following bar code, then use the
meric combination that represents that ASCII character. Scan
Serial Trigger Mode
You can activate the scan engine either by pressing the trigger, or using a serial trigger command (see
page 9-3). When in serial mode, the scan engine scans until a bar code has been read or until the deactivate command is sent.
The scan engine can also be set to turn itself off after a specified time has elapsed (see
Read Time-Out
Use this selection to set a time-out (in milliseconds) of the scan engine's trigger when using serial commands to trigger the
scan engine. Once the scan engine has timed out, you can activate the scan engine either by pressing the trigger or using
a serial trigger command. After scanning the Read Time-Out bar code, set the time-out duration (from 0-300,000 millisec-
onds) by scanning digits on the
Presentation Mode
Presentation Mode uses ambient light to detect bar codes. The LED dims until a bar code is presented to the scanner, then the
LED brightens to read the code. If the light level in the room is not high enough, Presentation Mode may not work properly.
Scan the following bar code to program your scanner for Presentation Mode.
Programming Chart
Deactivation Character
Programming Chart
inside the back cover, then scanning Save. Default = 30,000 ms.
Read Time-Out
Presentation Mode
inside the back cover of this manual to read the alphanu-
Save
to finish. Default = 14 [DC4].
Read
ASCII Conversion
Trigger Commands
Time-Out, which follows).
3 - 7
on