7
Care and Maintenance
7.8.10 Hydraulic oil return filter
Attention
• After a larger repair job, renew the filter
cartridge following the test run.
Changing the filter insert
•
Switch off the engine.
•
Unscrew the oil dipstick (57/1).
•
With the aid of a tool, remove the filter
cover (58/1).
•
Remove the filter element (58/5) along with the
inlet connection (58/3) by pulling and turning at the
same time.
•
Remove the filter element from the inlet
connection and dispose of according to
regulations.
•
Ensure that the seal (58/2) in the cover and the
O-ring (58/4) on the inlet connection are in
faultless condition and replace any damaged
parts.
•
Push a new filter element onto the inlet connection
and insert together in filter.
•
Screw back on the filter cover (58/1) and tighten
using a torque of 20 Nm.
•
Screw back in the oil dipstick.
•
Check the tightness of the filter by means of a test
run.
88
1
3
Fig. 57 Hydraulic oil tank
1
2
3
4
5
Fig. 58 Changing the filter insert
Operating Instructions Wheel Loader TL120
2
4
L844-051-1
L834-053