Terex TL120 Operating Instructions Manual page 57

6 Recovery, Loading and Transporting
6.1 Recovery
Towing of the wheel loader must be restricted to
clearing a junction or a road, to prevent damage to the
hydrostatic travel drive.
If possible, let the diesel engine run at low idle during
towing.
Machine damage
due to excessively fast towing.
• Tow the machine at walking speed.
Towing lugs
• Front: right and left on the axle plates.
• Rear bottom right and left on the side plates of the
rear end.
Attention
Max. load suspension of towing lugs
approx. 5,300 kg.
• Whenever the wheel loader has to be towed, for
whatever reason, the "Travel" oil circuit must be
opened so that the hydrostatic transmission no
longer acts as an auxiliary brake.
• At the two high-pressure relief valves (26/1) with
bypass, loosen the screw (27/1) by
approx. 3 turns.
• After towing, screw back in screw (27/1) until the
stop.
Machine damage
due to hydraulic system contamination.
• Absolute cleanliness is essential when
working on the hydraulic system.
Danger to life
due to rolling away of machine.
• Always secure the machine with chocks
and relieve the hydraulic system of
pressure before carrying out maintenance
and repair work.
Operating Instructions Wheel Loader TL120
Recovery, Loading and Transporting
Fig. 26 Hydraulic pump
Fig. 27 High-pressure relief valve
6
1
La85327
1
La85328
57